N Gauger's Scratchbuild '09 Summer Challenge - Printable Version +- (https://bigbluetrains.com) +-- Forum: Photographer's right of way (https://bigbluetrains.com/forumdisplay.php?fid=37) +--- Forum: Contests & Challenges (https://bigbluetrains.com/forumdisplay.php?fid=9) +--- Thread: N Gauger's Scratchbuild '09 Summer Challenge (/showthread.php?tid=1376) |
Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-14-2009 A little more finished on the rear of the building Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-14-2009 and another pic of the other side of the fan Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-14-2009 and the prototype Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-21-2009 Well, here it is, after 3 months trying to get it as close to the pictures as I could i lowered the bricks to where the ground line is, this will be were it sits even with my layout surface. Yes, I have to make a hole in the layout for this so it will sit at the correct height. The ground level is at the bottom of the concrete steps at the left of my pictire. Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-21-2009 The steam engine Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-21-2009 and the railing, in the prototype, it's taken from the view of the hallway, from my view, it's taken from the view as if the camera was over the mine shaft Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-21-2009 and the view of the right side airway Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 09-21-2009 and just to show that this actually works, I stuck 2 strips of paper to the chimney and: http://www.the-gauge.net/magazine/10.MOV Re: N Gauger's Scratchbuild '09 Summer Challenge - cgutzmer - 09-24-2009 Well this is pretty spiffy! I cant see the movie here at work but will check it out at home! Pretty good scratch build not too sure about that metal stuff in there though Chris Re: N Gauger's Scratchbuild '09 Summer Challenge - ngauger - 12-13-2009 Finally got the chance to set the fan house in place, I just have to detail the grade around it now The square cut out to the right is the Mine Vent tunnel, where the fan house will be venting. |