Video: Helper ops with DC - Printable Version +- (https://bigbluetrains.com) +-- Forum: Photographer's right of way (https://bigbluetrains.com/forumdisplay.php?fid=37) +--- Forum: Shutterbug area (https://bigbluetrains.com/forumdisplay.php?fid=6) +--- Thread: Video: Helper ops with DC (/showthread.php?tid=7176) |
Video: Helper ops with DC - Ralph - 11-13-2014 Hi, I've posted a short video about how I do helper ops on my DC powered layout. Not for everyone, but give it a look if you're curious. <!-- m --><a class="postlink" href="http://youtu.be/LTYVJS8K6fg">http://youtu.be/LTYVJS8K6fg</a><!-- m --> Ralph Re: Video: Helper ops with DC - Charlie B - 11-13-2014 Very nice video Ralph, You should get a second job as an MC. You have a great voice. Very good representation of the helpers too. I remember those F7's doing that service through here. Charlie Re: Video: Helper ops with DC - Ralph - 11-14-2014 Nice pic! Thanks Charlie! Re: Video: Helper ops with DC - jwb - 11-14-2014 Thee are interesting ideas. Adding a spur at the summit is one possibility, or a crossover, which would at least let the helpers get out of the way onto the other main. I designed my current layout with possible helper operation in mind, although I never followed through, at least on DC. I decided the way to do it on DC block control was to have a short block at the summit where I could uncouple the helpers (manually, with the train stopped) and either cut off the power for the helper block once I'd done this, or transfer the block to the other cab and let another operator run them back down. If you did successfully speed-match some helpers on your layout, you could also do this by just adding a short block at the summit, so you could run them up and down again without staging. It occurs to me that it would be an easy solution, requiring some rail gaps and a block selector switch, and you'd be in business. A crossover would be more work, but wouldn't use extra space. Re: Video: Helper ops with DC - jwb - 11-14-2014 Just for fun, here's a shot of the panel schematic where I designed in a short block for cutting off helpers: |