Switchers stalling? Please no.
#27
A completion to the thread:

[Image: dsc08935jyjo4.jpg]
This are modfied Athearn Blomberg trucks.

How to do:
1) pry off the bottom of the gear box
2) slide out the truck frames
3) solder each 4 pieces of 0,3mm bronze wire to each axle bearing as shown
4) solder the connection wires between main PCB and trucks direct onto the trucks and PCB
5) reassemble the whole

The bronze wire will make a direct and reliable electrical connection to the half axle. It must not exact being 0,3mm bronze wire, every other thin wire with a certain amount of springing will do it also.

greetings
Lutz
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)