Spilled soldering flux
#6
BR60103 Wrote:Don, I don't quite trust acetone on plastics and rubber.

I think the matte medium/scenic cement coating has worked for some of it. Didn't get time as we had an energy audit of the house today.

Yes, you have to be careful around plastic with acetone, but it evaporates quickly and if you're careful, it doesn't have time to do damage. So if alcohol works, that's a much better option. My only concern is if there's any flux residue it might bleed through the matte medium after a while.

I can envision your pain, it sounds so much like something that would happen to me, and that's scary...
Don (ezdays) Day
Board administrator and
founder of the CANYON STATE RAILROAD
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)