Did it again, 5.00 € Caboose Kitbash
#18
Hello,

thank you.

[Image: dsc03627wjrav.jpg]
Next was chaining it up.




[Image: dsc036283krzu.jpg]
The upper ends of the ladder ends were bed in an app. 30° angle and the excess was cut away.
The upper hanger for the hand brake equipment was bent out of 0,3mm soft brass wire and soldered onto the railing (sorry for the fuzzy photo)




[Image: dsc03629ago2i.jpg]
The brake shaft is 0,3mm bronze wire, the lower hanger and the brake wheel are kit surplus.
The brake hose mounting is by Kadee.
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)