+- (https://bigbluetrains.com)
+-- Forum: The Back Shop (https://bigbluetrains.com/forumdisplay.php?fid=52)
+--- Forum: DCC (https://bigbluetrains.com/forumdisplay.php?fid=38)
+--- Thread: Broadway Limited Locomotive Problems (/showthread.php?tid=10270)
Broadway Limited Locomotive Problems - tompm - 06-09-2026
Over the past few days I have been trying to run my Broadway Limited B&O EA locomotive. I tested the locomotive when I first got it, but I did not have the time to do a break-in session. A couple of nights ago I pulled the locomotive out to give it a proper break-in session.
At first things were going well. When I do break-in sessions I switch back and forth with sound on and off. Personally, I am not a fan of sound. After a time for me it just becomes noise. Also, I want to hear the locomotive and its motor.
I was running with the sound turned off and suddenly; the sound comes on. It took me several tries to get it turned off. Everything is good until a few moments later when the horn starts blowing continuously. Again, it took several attempts to turn the horn off. Then the bell comes on. I do a factory reset and things return to normal and I have no more issues and I call it a night.
Tonight I go to the layout to finish the break-in. The random sound turning on issues starts after a few minutes. Now if that is not enough the locomotive starts stalling at random spots. I do another reset and first it helps but then we are back to the sound and stalling issues. Another reset. I now try DC. The locomotive does not run.
At this point I pull out another locomotive. The locomotive is my LNE Bachmann DCC onboard 2-8-0 Consolidation. The Bachmann runs without any issues.
I am beginning to think I have a bad decoder. Am I right or could there be something else?