Just tinkering with my 1st section of the layout - Printable Version +- (https://bigbluetrains.com) +-- Forum: Mainline (https://bigbluetrains.com/forumdisplay.php?fid=17) +--- Forum: HO Modeling (https://bigbluetrains.com/forumdisplay.php?fid=21) +--- Thread: Just tinkering with my 1st section of the layout (/showthread.php?tid=368) |
Just tinkering with my 1st section of the layout - tomustang - 12-28-2008 My oddly jointed 18" + 22" curves, as my circle. I can 'play' on this when I work on the 4X8 main section which i'll add this to it on the side. The track is almost all on but the board isn't anywhere complete. The Circle Just threw on some stuff temporary Then played with Macro... Re: Just tinkering with my 1st section of the layout - LynnB - 12-28-2008 Well the circle part looks very round :mrgreen: Re: Just tinkering with my 1st section of the layout - Trucklover - 12-28-2008 Looking good Tom, i like the double stacks and the construction equipment, and of coarse the trucks Was that a Walthers Terex Dump Truck in a couple of the pics? Re: Just tinkering with my 1st section of the layout - COMBAT - 12-29-2008 Boley, I know that truck anywhere. LOL Nice double stacks too! Re: Just tinkering with my 1st section of the layout - Dan85 - 12-29-2008 Nice start Tom! I really like that container forklift - walthers kit? - Dan Re: Just tinkering with my 1st section of the layout - Russ Bellinis - 12-29-2008 Nice start. One potential problem for you is if you are like me, once you get some track down that trains will run on, you may end up going to work on the layout and figure I'll just run a train a little bit and 2-3 hours later, you have been running trains on the "plywood central" but nothing else got done. I would suggest you put up some sort of Masonite retaining walls where ever the track passes close to the edge. It looks like you have the potential to have trains that derail take the big fall to the floor. Re: Just tinkering with my 1st section of the layout - tomustang - 12-29-2008 Trucklover Wrote:Looking good Tom, i like the double stacks and the construction equipment, and of coarse the trucks Dan85 Wrote:Nice start Tom! I really like that container forklift - walthers kit?Thanks, and yes it's the Terex, which is the same as the Kirbi but a lot cheaper. The same goes for the walthers wheel loader and container forklift COMBAT Wrote:Boley, I know that truck anywhere. LOLThanks, nowhere near the awesomeness of your layout though Russ Bellinis Wrote:Nice start. One potential problem for you is if you are like me, once you get some track down that trains will run on, you may end up going to work on the layout and figure I'll just run a train a little bit and 2-3 hours later, you have been running trains on the "plywood central" but nothing else got done. The $ is the 1st problem, so plywood central will not get many renovations for a while Russ Bellinis Wrote:I would suggest you put up some sort of Masonite retaining walls where ever the track passes close to the edge. It looks like you have the potential to have trains that derail take the big fall to the floor. I know it's going to be a problem and everyone around me says the same thing, but for now it's open and used for slow pulling runs for testing out my stock. Eventully this first 4X4 board will get some incline terrains Re: Just tinkering with my 1st section of the layout - tomustang - 01-09-2009 Little updating here, I'm leaning more tward two main buildings, a plastics plant (Walthers Magic Pan Bakeries) and a pipe factory (Walthers Machine Shop) which will be not be used for a railroad machine shop I ended up curving the straight after the plastics plant to make room for more centerflow hoppers, after I finalize the location I'll make the piping system to feed the silos. I also got to look for some surge bins or a pump house outside. Re: Just tinkering with my 1st section of the layout - LynnB - 01-09-2009 Just curious , would that section be considered a reverse loop? Re: Just tinkering with my 1st section of the layout - Russ Bellinis - 01-09-2009 Lynn, I think it is just a circle with a couple of sidings. Re: Just tinkering with my 1st section of the layout - tomustang - 01-10-2009 wgrider Wrote:Just curious , would that section be considered a reverse loop? It's just a circle right now, until i build the 2nd board this will be remade into one 180 degree turn with some branches Re: Just tinkering with my 1st section of the layout - Ralph - 01-10-2009 I like the new plastics plant a lot. Nice collection of vehicles too! Ralph |