07-13-2021, 09:21 AM
Making some progress, got the hole in the floor repaired just minutes before the building inspector showed up. He'll never know. He was not concerned about the pit in the rear floor when we told him we were digging a well. 
Working on the front porch details, got to even out the wood floor color a bit, but at least it's painted. The sign above is suppose to read, "GeneraL", but the 3D printer didn't quite make all the letters, looks like the lettering is in Klingon. I needed to grind it off anyway so I can use it to inset a new sign. That worked out OK.
I took a photo of the brush that I'm using for detailing the small stuff, It's marked 5/0 and I'm not sure, but that "5" might be the number of bristles left on it.
I have another one marked 10/0 which should be even smaller, but it isn't. I think this one is just worn down, but it works for what I'm doing. Still tricky getting past those posts on the porch. They're next to be painted after the doors.
Working on the front porch details, got to even out the wood floor color a bit, but at least it's painted. The sign above is suppose to read, "GeneraL", but the 3D printer didn't quite make all the letters, looks like the lettering is in Klingon. I needed to grind it off anyway so I can use it to inset a new sign. That worked out OK.
I took a photo of the brush that I'm using for detailing the small stuff, It's marked 5/0 and I'm not sure, but that "5" might be the number of bristles left on it.
I have another one marked 10/0 which should be even smaller, but it isn't. I think this one is just worn down, but it works for what I'm doing. Still tricky getting past those posts on the porch. They're next to be painted after the doors.
Don (ezdays) Day
Board administrator and
founder of the CANYON STATE RAILROAD
Board administrator and
founder of the CANYON STATE RAILROAD