02-16-2014, 10:58 AM
Well a few days turned into a couple of weeks...been off Cozumel for some dives...
Started the final version of the control panel, no more practicing...the acrylic panel is difficult to drill into...a drill press is a real good idea. With a lot of patience, I managed to get all the holes drilled without cracking
The LEDs and trim bezels fit nicely in a 9/32 hole...
The mini-toggle dpdt on-on switches will also drop into the same sized holes...
Wires, wires, and more wires to come
Next will be to use a mini hacksaw blade to cut out the square hole for the Digitrax Zephyr
Started the final version of the control panel, no more practicing...the acrylic panel is difficult to drill into...a drill press is a real good idea. With a lot of patience, I managed to get all the holes drilled without cracking
The LEDs and trim bezels fit nicely in a 9/32 hole...
The mini-toggle dpdt on-on switches will also drop into the same sized holes...
Wires, wires, and more wires to come
Next will be to use a mini hacksaw blade to cut out the square hole for the Digitrax Zephyr