08-29-2015, 01:04 PM
Sorry Dan I saw your comment jus after I finished the fabrication of the new yoke.
I used my drill press to connect the holes together. This is how far I got when the drive belt in my drill press disintegrated.
I finished it off with my dremel tool and a set of jeweler's files.
Finally I used some small diameter square tubing to replicate the mounting tabs. I glued them in with JB Weld so they'll never come back out.
I used my drill press to connect the holes together. This is how far I got when the drive belt in my drill press disintegrated.
I finished it off with my dremel tool and a set of jeweler's files.
Finally I used some small diameter square tubing to replicate the mounting tabs. I glued them in with JB Weld so they'll never come back out.