07-23-2016, 05:48 AM
I'm seriously thinking of using a new kind of support for the shelf of my shelf layout.
The last one was the standard section metal channel set on the wall (Brick) with the triangular steel arms that slot in. This time I want a seamless and very neat solution, a lot like Lance has been experimenting with. I found this which I think would worl well, the only change I would make is to leave out the bottom board (to allow access to wires) and then I would only use a 1/8th inch MDF or Masonite board on top, laminated to the 1 inch thick insulation board.
The last one was the standard section metal channel set on the wall (Brick) with the triangular steel arms that slot in. This time I want a seamless and very neat solution, a lot like Lance has been experimenting with. I found this which I think would worl well, the only change I would make is to leave out the bottom board (to allow access to wires) and then I would only use a 1/8th inch MDF or Masonite board on top, laminated to the 1 inch thick insulation board.
Callum
My previous build : http://bigbluetrains.com/forum/viewtopic.php?t=4271
Video: https://www.youtube.com/watch?v=d4rqsg4x6og https://www.youtube.com/watch?v=v_gRKWo-q3A
My previous build : http://bigbluetrains.com/forum/viewtopic.php?t=4271
Video: https://www.youtube.com/watch?v=d4rqsg4x6og https://www.youtube.com/watch?v=v_gRKWo-q3A