04-13-2009, 10:04 AM
Personally, I'd go with flex for all of the track, but you can also trim sectional track and turnouts, too. Use a razor saw, rail nippers, or a cut-off disc in a Dremel for the rails, and a utility knife to cut the tie strip.
In the photo below, the turnout nearest the bottom (not the one with the visible switch stand), and a corresponding one at the opposite end of the passing siding, both had their diverging rails shortened in order to force the two tracks closer together, as I had very limited space between the station and the turntable:
[album]790[/album]
Wayne
In the photo below, the turnout nearest the bottom (not the one with the visible switch stand), and a corresponding one at the opposite end of the passing siding, both had their diverging rails shortened in order to force the two tracks closer together, as I had very limited space between the station and the turntable:
[album]790[/album]
Wayne