08-11-2009, 02:05 PM
jglfan Wrote:Thanks Mountainman. Andrew, I needed 1/2" to match the window width. I could only gey strip in 1/4". I did not wish to make my own spacers from styrene sheet, as I knew I would get square edges with strip, even a bit off cutting from sheet would have caused problems. Having so many pcs to cut, I felt it was highly likely a few would wind up not square. I'm just not that good! The walls have between 8 and 18 windows each, so that's a lot of part cutting.
Thanks, I misunderstood the part where you said you used the two 1/4" wide strips - I did not realize it came that way.
Andrew