03-11-2010, 06:19 PM
After I removed the coil springs I started shaping the leaf springs.
I did this by filing the edge of some scrap plastic to give it the profile of the individual leaves. Then I measured the width of the spring and cut it to size with a Chopper.
I'm glad that I only have to do this for one car because It's no fun. With the 4 springs cut I glued them in place of the coil springs.
I also roughed up the floor of the interior to to give it a more used appearance.
I'm glad that I only have to do this for one car because It's no fun. With the 4 springs cut I glued them in place of the coil springs.
I also roughed up the floor of the interior to to give it a more used appearance.
My other car is a locomotive, ARHS restoration crew