03-12-2010, 05:56 PM
I picked up the "thru-the-wall" sleeve for the air conditioner today. I'll get it put in this weekend and finish the sheetrock that has been left out because of the sleeve. Then I'll hire a finisher and hopefully will be done in a week or so.
Bending the shelf rails wasn't all that bad. Back on the "old Gauge" we had quite the discussion of how to level the brackets/benchwork - from shims to leveling bolts installed in the brackets to grinding the brackets a bit at the rail/bracket junction to just making the benchwork dimensions in the front a little less than in the back. Then I discovered the "brute force" method and used that.
Bending the shelf rails wasn't all that bad. Back on the "old Gauge" we had quite the discussion of how to level the brackets/benchwork - from shims to leveling bolts installed in the brackets to grinding the brackets a bit at the rail/bracket junction to just making the benchwork dimensions in the front a little less than in the back. Then I discovered the "brute force" method and used that.
Three Foot Rule In Effect At All Times