12-03-2010, 03:11 AM
I found the answer!!! 
at least for my controller, but they should be similar.
according to my NCE Powercab manual there is a thing called "Binary CV programming".
the instructions are kinda iffy on how to change the bits, but from what I can figure out it should work just like programming a CV value.
the instructions may be different for your controller, but I hope this helps anyways
If you still need help there is a primer on Binary CVs starting at page 23 in the Paragon2 DCC technical manual Here:http://www.broadway-limited.com/support/...Diesel.pdf
at least for my controller, but they should be similar.
according to my NCE Powercab manual there is a thing called "Binary CV programming".
the instructions are kinda iffy on how to change the bits, but from what I can figure out it should work just like programming a CV value.
the instructions may be different for your controller, but I hope this helps anyways
If you still need help there is a primer on Binary CVs starting at page 23 in the Paragon2 DCC technical manual Here:http://www.broadway-limited.com/support/...Diesel.pdf
Justin Miller
Modeling the Lebanon Industrial Railway (LIRY)
Modeling the Lebanon Industrial Railway (LIRY)