Micro Enginnering bridge instructions
#4
I thought this thread was dead. I hope you can find them Sumpter. No biggie if you don't. This kit has very brittle plastic. Many of the parts are busting, even before I snip them off the tree. The only gluing I've done so far is put pieces back together. I'm wondering about the stability of this thing when it becomes a permanent part of the layout. I didn't really want to put together a kit anyways. The only other bridges I liked were pre-assembled truss bridges that run about $200, more than I was willing to pay, but I may have to. Yes, this is a deck girder bridge, the 320' one, which is why I need the instructions. There are instructions for the smaller spans, but since the 320' length is an add-on kit, there were supposed to be additional instructions. That is what I am missing. I should have time to work on it this weekend. Thanks.
"You did NOT cut a hole in the wall for the train, did you?" - the wife
The Waynesburg Southern
Blue Mountain Aerial Mapping
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)