03-16-2011, 05:46 PM
"Mark, there may be a way to dim that bulb using a CV adjustment. You might want to as on the DCC thread if you don't have the instructions."
Charlie
I'm afraid not....There's no CV that controls light brightness.
The only way to dim the light is to put a resistor in series on the white or yellow leads between the decoder and the bulb. I believe I used a 700 (or 70..??) ohm resistor to dim the light a bit on my SD-7.
Charlie
I'm afraid not....There's no CV that controls light brightness.
The only way to dim the light is to put a resistor in series on the white or yellow leads between the decoder and the bulb. I believe I used a 700 (or 70..??) ohm resistor to dim the light a bit on my SD-7.
Gus (LC&P).