04-02-2011, 03:41 PM
I'll let you know. My ME turnouts are due to be shipped in May, I'll get them too but the Shinoharas will be on this layout.
I do know that Andy at proto87 knows about 00sf the bit I linked to earlier regarding narrowing the gauge to 16.2mm so you can narrow the flangeway to 1mm, although not official 00sf can be referred to as 00-superfine, so I have a feeling that this might be what you linked to although the gauge is not mentioned.
I've used everything from Peco code 100 to fully soldered, part soldered part plastic and glued plastic chairs full detail and little detail, its best not to get too caught up on trackwork as you can make anything look good with a little effort.
ps I'm on rmweb too have been for years my username is the same and I'm following the same threads as you at the moment, seems strange you refering to me on here in a post on there.
I do know that Andy at proto87 knows about 00sf the bit I linked to earlier regarding narrowing the gauge to 16.2mm so you can narrow the flangeway to 1mm, although not official 00sf can be referred to as 00-superfine, so I have a feeling that this might be what you linked to although the gauge is not mentioned.
I've used everything from Peco code 100 to fully soldered, part soldered part plastic and glued plastic chairs full detail and little detail, its best not to get too caught up on trackwork as you can make anything look good with a little effort.
ps I'm on rmweb too have been for years my username is the same and I'm following the same threads as you at the moment, seems strange you refering to me on here in a post on there.
My Miami NW 22nd St layout and modelling blog http://dlmr.wordpress.com/ Please come by and leave a comment.