07-30-2011, 06:57 PM
Green_Elite_Cab Wrote:This is what I initially thought, and so I promptly drilled a hole down the center of an LED long enough to let a short length of Fiber optic be relatively secure. Unfortuneately, this "fogged" the LED around the hole. The light was not nearly as bright as if i had just held the LED to the surface. If there is a way to polish it clear, this method would probably be prefered.
Did you use a pin vise or a powered drill? If the latter, it may have melted the LED slightly, causing the fogging. In either case, try using the same bit in a pin vise, but turn it counterclockwise to polish the already-drilled hole.
Wayne