10-12-2011, 07:16 PM
Cool! I didn't know this was re-released. Some n-gauge locomotives are able to "re-gauge" to HOn3 by slightly pulling the half-axles out of their center gear. N-gauge is 9mm, and HOn3 is 10.5mm, so that means each half axle needs to be pulled out of the gear by only 0.75mm. Do you think one could do the same for this locomotive? If so, it may be relatively easy for me to make a representation of one of these:
<!-- m --><a class="postlink" href="http://narrowmind.railfan.net/242T-tenderMARR2.jpg">http://narrowmind.railfan.net/242T-tenderMARR2.jpg</a><!-- m -->
<!-- m --><a class="postlink" href="http://narrowmind.railfan.net/242T-tenderMARR2.jpg">http://narrowmind.railfan.net/242T-tenderMARR2.jpg</a><!-- m -->
--
Kevin
Check out my Shapeways creations!
3-d printed items in HO/HOn3 and more!
<!-- m --><a class="postlink" href="https://www.shapeways.com/shops/kevin-s-model-train-detail-parts">https://www.shapeways.com/shops/kevin-s ... tail-parts</a><!-- m -->
Kevin
Check out my Shapeways creations!
3-d printed items in HO/HOn3 and more!
<!-- m --><a class="postlink" href="https://www.shapeways.com/shops/kevin-s-model-train-detail-parts">https://www.shapeways.com/shops/kevin-s ... tail-parts</a><!-- m -->