Lets build a camelback,, or two.
#93
Moving onward,,
I have started on some of the plumbing on the 2-10-0's. I'll start by showing the cold water feed from the tender, it is just a 2 inch scale pipe that runs on either side of the loco up into the cab where the injectors would be located.
   


I also shaped some of the piping that will be placed under the walkways. I did this by forming some brass wire around some nails and soldering some hangers to it. This picture shows one that is complete and one that's in the works.
   

after they were formed I attached them to the walkways with some CA glue.
   
 My other car is a locomotive, ARHS restoration crew  
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)