10-25-2012, 04:16 PM
kamerad47 Wrote:What about A TCS keep alive decder for one of these????? Will it help mine runs Bad!!!I am afraid it will not help. I use top notch ZIMO decoders (MX630) in six units and ESU Lokpilot in two units. It makes no difference. It is a pure mechanical problem of the drive.
I suggest you disassemble the engine and both trucks and assemble it very carefully. Do not tighten the two screws in the trucks to much. The trucks should run free on the table. That helps in some cases to reduce, but not eliminate, the noise.
Reinhard