02-07-2013, 09:06 PM
GAH!
I broke one of my tiny bits off inside the model and cannot get it out. The little bit that it there is too short to grab with pliers. I suppose the only thing I can to is file it down and spot the holes for the grab just above or below it, but if anyone has any ideas so that I can extract the bit I'd appreciate it.
I broke one of my tiny bits off inside the model and cannot get it out. The little bit that it there is too short to grab with pliers. I suppose the only thing I can to is file it down and spot the holes for the grab just above or below it, but if anyone has any ideas so that I can extract the bit I'd appreciate it.