06-20-2009, 06:43 PM
The DC/DCC controversy exists mostly in the mind of modelers.....If you're running a DC layout, all you have to do to "convert" to DCC is unplug your DC pack, and put the DCC control in its place, turn it on, and you're all set. A couple of decoders in Plug & Play equipped locos (a few minutes time), and you're up & running...
What you DEFINITELY don't want to do is have DC and DCC controllers hooked up at the same time (assuming you have a DC block system installed). You could let the smoke out of a lot of components if you do.....
What you DEFINITELY don't want to do is have DC and DCC controllers hooked up at the same time (assuming you have a DC block system installed). You could let the smoke out of a lot of components if you do.....
Gus (LC&P).