06-05-2010, 08:09 PM
Matt:
I don't think I have any sagging problems. I have L-girders with 1x1 (approx) crosspieces every foot.
I have a couple of places where the support was badly put in and I have a hump. I have a joint where I spliced it with a 1x2 which is thicker than my "1x1" and there is a little rise there. The layout is pretty flat as I didn't have a lot of space above it.
I keep my furnace fan on continually so the basement air is dry. When we changed furnaces they gave us a switch and when I had it of for a couple of weeks it seemed damper so I turned it on again.
I don't think I have any sagging problems. I have L-girders with 1x1 (approx) crosspieces every foot.
I have a couple of places where the support was badly put in and I have a hump. I have a joint where I spliced it with a 1x2 which is thicker than my "1x1" and there is a little rise there. The layout is pretty flat as I didn't have a lot of space above it.
I keep my furnace fan on continually so the basement air is dry. When we changed furnaces they gave us a switch and when I had it of for a couple of weeks it seemed damper so I turned it on again.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.