08-09-2011, 03:53 PM
The two ends and tank wrapper were cut from .010" brass sheet.
The bends were formed starting from the inner bends and working outward.
The sheet was clamped between two 1/4" steel bars.
The first two bends completed.
The third bend in position ready to be folded.
Twisting the bars to make the bend.
The bends were formed starting from the inner bends and working outward.
The sheet was clamped between two 1/4" steel bars.
The first two bends completed.
The third bend in position ready to be folded.
Twisting the bars to make the bend.
Ray Marinaccio