08-09-2011, 03:59 PM
A 3/16" bar was used to make the final bends.
The completed wrapper.
The ends and wrapper were test fitted.
Some filing was required to get a good fit.
The parts were removed from the frame and the ends were soldered on at the bottom corners only.
The tank was refitted on the frame and the ends were soldered.
The completed wrapper.
The ends and wrapper were test fitted.
Some filing was required to get a good fit.
The parts were removed from the frame and the ends were soldered on at the bottom corners only.
The tank was refitted on the frame and the ends were soldered.
Ray Marinaccio