08-10-2011, 09:04 AM
I took a few photos of the MDC shay I'm working on.
What started as a simple tune-up turned into a major rebuild.
This photo shows the MDC/Athearn drive-shaft To complete the re-power.
I regauged this one to standard gauge by replacing the axles and installing these spacers on the side frames.
This shows the relocation of the air tank.
The lowered toolbox and modified pilot.
What started as a simple tune-up turned into a major rebuild.
This photo shows the MDC/Athearn drive-shaft To complete the re-power.
I regauged this one to standard gauge by replacing the axles and installing these spacers on the side frames.
This shows the relocation of the air tank.
The lowered toolbox and modified pilot.
Ray Marinaccio