08-10-2011, 09:11 AM
Some modifications around the cab area.
This shows the rear sand box.
That's where I am with this project. I need to fabricate wipers for electrical pickup and wire it, then finish detailing and painting.
More later.
The rear sand box is the original MDC box with a few modifications. The center was cut out, then styrene fillers installed.
Notches were filed at the bottoms of the boxes.
Then a sheet of styrene was installed to represent the back of the water tank.
This photo shows the back temporarily in place before the notches were filed.
This shows the rear sand box.
That's where I am with this project. I need to fabricate wipers for electrical pickup and wire it, then finish detailing and painting.
More later.
The rear sand box is the original MDC box with a few modifications. The center was cut out, then styrene fillers installed.
Notches were filed at the bottoms of the boxes.
Then a sheet of styrene was installed to represent the back of the water tank.
This photo shows the back temporarily in place before the notches were filed.
Ray Marinaccio