02-19-2012, 07:24 AM
Let' see...
1) Put the back drops in FIRST, before laying track. (At the time, I had a good reason for not doing it first...).
2) Put down a layer of foam board instead of using just plywood (did this on phase II).
3) Add jumper wires to the points on my switches BEFORE installation. (Of course, I discovered the jumper wires to the points from a friend of mine after I had the turnouts installed).
Other than that, I am happy with what I have done so far.
Chuck
1) Put the back drops in FIRST, before laying track. (At the time, I had a good reason for not doing it first...).
2) Put down a layer of foam board instead of using just plywood (did this on phase II).
3) Add jumper wires to the points on my switches BEFORE installation. (Of course, I discovered the jumper wires to the points from a friend of mine after I had the turnouts installed).
Other than that, I am happy with what I have done so far.
Chuck
Detroit Connecting
We are your
inner-city connection.
We are your
inner-city connection.