05-15-2013, 12:37 PM
Still not sure how much plastic the skull took but here are 2 size comparasions to give a general idea of the size.
I thought I had 2 pics but there is only one.
I test printed a basic rectangle with a smaller rectangle hole that is aprox. the size of a 40' box car side in S scale it was half a success as the ends started to curl up and caused a slight jam, I need to clean up the build platform as oil from hands and fingers will cause the plastic not to adhear to the build platform
Getting closer to useable train parts 
In case sumpter is following this theard I printed half of the enterprise from a file on thingaverse :ugeek:
I thought I had 2 pics but there is only one.
I test printed a basic rectangle with a smaller rectangle hole that is aprox. the size of a 40' box car side in S scale it was half a success as the ends started to curl up and caused a slight jam, I need to clean up the build platform as oil from hands and fingers will cause the plastic not to adhear to the build platform
Getting closer to useable train parts In case sumpter is following this theard I printed half of the enterprise from a file on thingaverse :ugeek: