Need a drill for small bits (#80)

[Schraddel]

..., but it would be nice if someone made a small drill press with a small chuck that can hold these tiny drills and adjust down to maybe 30-60 RPM. It would make short work of drilling holes for grab irons, and having everythng secure in a drill press would proably prevent bit breakage. I tend to break bits when I either apply too much pressure, or when the bit is partially in the hole and I don't keep the pin vise perpendicular.

Kevin!

Before several years i bought this:

A 0,3mm drillbit in the chuck.


A drill stand making my electric drill to a drill press and as complementary a compound table.
This is not a heavy duty piece, this is intended for those fine work which we Model Railroaders do.


An other use is for cutting tubes and profiles. Here i am able to cut 0.2mm rings out of tube stock.
Milling work also is possible. But the more coarse kind of work like milling a diesel chassis to create space for an decoder.

My 2 Cent

Lutz