07-31-2014, 08:22 PM
I try not to solder to turnouts or other expensive track if there's an alternative. But I did do it on a bunch of them a few years ago.
I would possibly solder a joint between two three-foot sections with a feeder and leave the ends slightly loose (a bit of a gap in the rail joiner). Not a sloopy rail joiner!
I would possibly solder a joint between two three-foot sections with a feeder and leave the ends slightly loose (a bit of a gap in the rail joiner). Not a sloopy rail joiner!
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.