01-01-2017, 02:39 PM
Here go's on today's progress,,, The Cab.
This was cut from thin styrene, and embossed with rivets on my rivet press. I went with the Brooks style cab with the offset arched window as used on most CNJ and SH&D camels.
Here are the side panels.
The front and rear ends.
My very advanced squaring jig.
It will take some fitting until it fits nice and snug.
I added some internal bracing to help stiffen it up.
This was cut from thin styrene, and embossed with rivets on my rivet press. I went with the Brooks style cab with the offset arched window as used on most CNJ and SH&D camels.
Here are the side panels.
The front and rear ends.
My very advanced squaring jig.
It will take some fitting until it fits nice and snug.
I added some internal bracing to help stiffen it up.
My other car is a locomotive, ARHS restoration crew