01-11-2017, 02:56 PM
The support structure is aligned and glued to the base. The bridges are set in place.
The rod has been replaced! The prototype uses something like a large hook to lift the coils too. May be I try that too.http://media.al.com/mobile-press-registe...-large.jpg
Everything must set until some weathering will be applied. May be some warning signs are fine too.
I did not add the crane operator cabin. I think a hand held operating console hanging at a cable might be more likely.
IMG_5303 by faraway52, on Flickr
The rod has been replaced! The prototype uses something like a large hook to lift the coils too. May be I try that too.http://media.al.com/mobile-press-registe...-large.jpg
Everything must set until some weathering will be applied. May be some warning signs are fine too.
I did not add the crane operator cabin. I think a hand held operating console hanging at a cable might be more likely.
IMG_5303 by faraway52, on Flickr
Reinhard