Old Steamers

[cnrglen]

I believe I used a mix of CA and epoxy for the MDC locos that I reworked over the past year. The larger components usually have a mounting pin or post that you can use for mounting them, if not you can drill the part out and add one. When I added the sanding lines to my engines I drilled through the running boards using my small drill press. I found that the die-cast boiler was not the easiest thing to drill into but it was doable.

Just in case you haven't seen it, this is my MDC engine rebuild thread:
<!-- l --><a class="postlink-local" href="http://bigbluetrains.com/forum/viewtopic.php?f=17&t=8413">viewtopic.php?f=17&t=8413</a><!-- l -->