03-30-2024, 02:44 PM
So I have been really struggling with the pin vises I have to get them to work reliably. I’m certain a portion of this is user error but I’ve bought two now and can’t seem to get either to reliably hold on to drill bits. I have one that I bought from Kadee that has four collet sizes and all of the sizes are either too big or too small, and another I bought from micro mark with a spring that just doesn’t seem to want to hold anything bigger than the ten or so smallest bits in my bit set (a 60-90 set). I can just forget holding bigger bits or taps in it, too.
So… What pin vise do you use? Do you have any advise for setting one up?
So… What pin vise do you use? Do you have any advise for setting one up?
————————————————————————————
Modeling the East Broad Top as it was between 1937-1942
~Amanda
Modeling the East Broad Top as it was between 1937-1942
~Amanda