09-13-2019, 04:21 PM
The most difficult was the arc of the roof top. Once my friend & I figured it out, I cut the joists out of the sheet of basswood.
i clamped and glued them to cross beams i installed across the tops of the uprights.
i also mounted a cross beam across the brass rods I put in the front of the engine and a support beam on the side of the roof joists.
next step is to install the other side support beam and design the steam boiler.
i clamped and glued them to cross beams i installed across the tops of the uprights.
i also mounted a cross beam across the brass rods I put in the front of the engine and a support beam on the side of the roof joists.
next step is to install the other side support beam and design the steam boiler.
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???