08-29-2013, 08:16 PM
Perfect. The Bullfrog comes with a switch that you build in.
(Brief pause while I look at the one I installed.)
The tab at one end of the switch goes to the frog wire. The other 2 tabs are connected to the running rails -- any convenient place but possibly not on the turnout itself (unless there are space reasons). I tend to solder 3 wires to the switch and 3 other wires to the track and twist the ends together or use alligator clips to test that I have then right.
(There are only 6 combinations of wires to rails).
(Brief pause while I look at the one I installed.)
The tab at one end of the switch goes to the frog wire. The other 2 tabs are connected to the running rails -- any convenient place but possibly not on the turnout itself (unless there are space reasons). I tend to solder 3 wires to the switch and 3 other wires to the track and twist the ends together or use alligator clips to test that I have then right.
(There are only 6 combinations of wires to rails).
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.