04-25-2014, 05:17 PM
If you want 4-bolt railbars, you just have to cut them to the correct length. They are glued in place with CA. Some people use Code 70 railbars on Code 83 for better clearance. If I had to redo this again, I think I would use Code 83 outside the rail and Code 70 inside the rail. That would save some adjustment.
For the gaps, I'll see. I think a file would give more control. A Dremel cutting disk seems a little bit large for this.
Matt
For the gaps, I'll see. I think a file would give more control. A Dremel cutting disk seems a little bit large for this.
Matt
Proudly modelling Quebec Railway Light & Power Company since 1997.
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/