07-16-2014, 03:58 PM
@ Lutz: You're totally right. Where rough surfaces are needed, that's probably the best thing out there. The technology and cost are not up to date for HO stuff, except if you wish to put a lot of bucks in the bucket. Also, hard to tell what is these material's shelf life. We will see.
@Nacho! It's been years I wanted to try. I think the technology is probably quite good for small non structural parts, but not for entire 60' long cars.
Matt
@Nacho! It's been years I wanted to try. I think the technology is probably quite good for small non structural parts, but not for entire 60' long cars.
Matt
Proudly modelling Quebec Railway Light & Power Company since 1997.
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/