12-23-2014, 12:51 PM
This is something I have been avoiding doing, but I probably will have to do at some point.
I have a bunch of the old Athearn wheels in my American GK E60CH locomotives. The old steel wheels pick up grime at an extraordinary rate, and this is the primary reason they haven't been showing up as much on my layout and at the club.
The only problem I have is that some of the old trucks don't have the "inside" bearings like most Athearn stuff does these days. I wonder if they make wheel sets for side-frame-supported axles?
I have a bunch of the old Athearn wheels in my American GK E60CH locomotives. The old steel wheels pick up grime at an extraordinary rate, and this is the primary reason they haven't been showing up as much on my layout and at the club.
The only problem I have is that some of the old trucks don't have the "inside" bearings like most Athearn stuff does these days. I wonder if they make wheel sets for side-frame-supported axles?
Modeling New Jersey Under the Wire 1978-1979.
![[Image: logosmall.png]](http://i543.photobucket.com/albums/gg445/CAB_IV/Model%20Trains%202013/logosmall.png)