MDC/ROUNDHOUSE locomotive rebuilds
#4
Thanks to Sumpter's generosity I have the Main rod, crosshead and crosshead guide that I was looking for. Still looking for a yoke. Bowser has one but I am contemplating building one myself. since it's not really a structural or moving piece.

Well I started fitting the new cab to the boiler and frame.
[Image: 003_zpsw0xvcnbh.jpg]

It looks like the spectrum cab is the same size as the MDC one so I only need a few minor modifications to make it fit
[Image: 001_zpsersdn70w.jpg]

First I need to 'channel' the cab over the running boards to drop it. the boiler is pretty much the same diameter as the hole in the cab . I'm wondering if I should cut slots in the running boards or trim the front cab walls down.

[Image: 002_zpsqesi5ktt.jpg]

The other issue is the tab on the rear of the frame that was supposed to go in a slot in the MDC cab. Once the cab is dropped I have to cut a slot in the back for this tab but the everything should fit right.
The other thing I'm planning is to sand the cast-in hatches and details from the roof. I think it makes it look a bit too modern of what I'm going for.
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)