10-17-2015, 07:53 AM
Here is a picture of my frames I use for my squish molds:
the master is put in the mold upside down and and keeper rods inserted:
The RTV is poured into the lower mold:
The mold is turned right side up and the upper frame is placed and poured:
Remove the upper portion and the mold and you have a completed mold. Removing the keeper rods allow the molds to be slid out of the frame:
the master is put in the mold upside down and and keeper rods inserted:
The RTV is poured into the lower mold:
The mold is turned right side up and the upper frame is placed and poured:
Remove the upper portion and the mold and you have a completed mold. Removing the keeper rods allow the molds to be slid out of the frame: