11-10-2015, 11:41 PM
I had another project on the side that I had to complete but now I'm back with the 4-6-0
![[Image: DSCF5161_zps8mfzj18p.jpg]](http://i219.photobucket.com/albums/cc278/OkanaganIroc/model%20railroad/Engines/MDC%204-6-0/DSCF5161_zps8mfzj18p.jpg)
I spent some time this evening with my dremel tool's sanding drum and some sanding sticks and ground off the cast-on injectors, steam lines and sanding lines. The grinding isn't perfect but the new lines will go right over and hopefully cover the remnants. I also cut/ground off the cast-on bell.
![[Image: DSCF5163_zpst2yhzwve.jpg]](http://i219.photobucket.com/albums/cc278/OkanaganIroc/model%20railroad/Engines/MDC%204-6-0/DSCF5163_zpst2yhzwve.jpg)
I got a package in the mail this past week from Wiseman Model services. In it were cast brass injectors, water check valves and a power reverser. I'll start installing these and the accompanying water/steam/sand/air lines.
I spent some time this evening with my dremel tool's sanding drum and some sanding sticks and ground off the cast-on injectors, steam lines and sanding lines. The grinding isn't perfect but the new lines will go right over and hopefully cover the remnants. I also cut/ground off the cast-on bell.
I got a package in the mail this past week from Wiseman Model services. In it were cast brass injectors, water check valves and a power reverser. I'll start installing these and the accompanying water/steam/sand/air lines.