60´Gallows turntable for HOn3

[Graffen]

A small update:
The cork wasn't totally flat for the pit rail, so I mounted a template/scraper on my centre jig. I then spackled the surface and rotated the template to get a flat surface. It worked great!


I made some ties for the pit rail:


I glued them using my jig to get them to point towards the centre.

As you can see in the picture above, I made another template on the jig.
This one were to make the slope in the pit.
I mixed some very soupy plaster which I poured in the pit at the same time as I rotated the template.
After a minute or two, it began to set. I then removed the template (which had a roll of excess plaster on one side).
This is how it looked;


I added some thin paint to prepare for the gravel and sand:


The piedestal was painted as well.