01-21-2016, 08:31 AM
Yes, but ....
If you got a Tsunami decoder designed for Athearn units they are made to use for 1.5V bulb use made. LED require about 3V and will not work. There should be a soldering point on the PCB labeled 14V or something like that. That soldering point together with the minus connector at the ends is your to connect LEDS "with" a 1000 Ohm resistor.
LEDs must be connected with 1000 Ohm resistors to the end connectors if you got the decoder not intended for Athearn units.
There should be a wiring diagram printed on the cardboard with the decoder.
Please refer to the Tsunami diesel owners manual for details. It explains how to use Athearn specific decoders with LED and 12V specific decoders with micro bulbs.
If you got a Tsunami decoder designed for Athearn units they are made to use for 1.5V bulb use made. LED require about 3V and will not work. There should be a soldering point on the PCB labeled 14V or something like that. That soldering point together with the minus connector at the ends is your to connect LEDS "with" a 1000 Ohm resistor.
LEDs must be connected with 1000 Ohm resistors to the end connectors if you got the decoder not intended for Athearn units.
There should be a wiring diagram printed on the cardboard with the decoder.
Please refer to the Tsunami diesel owners manual for details. It explains how to use Athearn specific decoders with LED and 12V specific decoders with micro bulbs.
Reinhard