Small Stamp Mill

[cnrglen]

I managed to get the roof sheets onto my stamp mill these past couple days.

I had to cut, paint and glue most of the panels one at a time. turns out my model wasn't as square as I thought it was.



one flaw was I made one smaller wall a bit too short, resulting in the gap you see at the peak. I'll make a patch for this and probably add a vent to hide the flaw.
Not I have to calculate the square inches of the roofs to I can figure out how much corrugated roofing material I'll need. Then I'll have to order it. In the mean time I can work on the corner and roof trim as well as the foundation.
A lot of work to be done yet.