03-30-2009, 03:06 PM
On the topic of building a brass model using soldering methods, I wonder if this is where a Resistance Soldering Station would be more practical then an iron?
Just putting it out there as I have been drooling over a couple of small RSS set-ups for sometime now and wondering if detailed brass work might benefit from this method of soldering? :|
Granted, yes they are expensive, and there is a bit of learning curve on how to properly use one but... well you know how it is. It's like walking into the tool department at the Home Depot and seeing the latest high powered, cordless, do all tool and saying,
"Boy, I could sure use one of those."
Once again great stuff Kurt. Can't wait to see the finished trucks.
Just putting it out there as I have been drooling over a couple of small RSS set-ups for sometime now and wondering if detailed brass work might benefit from this method of soldering? :|
Granted, yes they are expensive, and there is a bit of learning curve on how to properly use one but... well you know how it is. It's like walking into the tool department at the Home Depot and seeing the latest high powered, cordless, do all tool and saying,
"Boy, I could sure use one of those."
Once again great stuff Kurt. Can't wait to see the finished trucks.